FLEXDAQ DATA LOGGERS

Ideal for remote monitoring in both common and demanding geotechnical conditions

How to Read the Data File from CR Loggers using Excel
How to Read the Data File using Excel: Open Excel program and browse to the file location Choose to read all files types Select Delimited and click on N...
Wed, 13 Oct, 2021 at 12:25 PM
How to setup a RST RSTAR enabled FlexDAQ System to communicate via CS CELL2xx Cell Modem.
Scenario: Customer have a FlexDAQ and would like to set up a Cellular communication to enable the system to be accessed via LoggerNet. Solution: Use a CELL...
Fri, 15 Oct, 2021 at 10:15 AM
How to connect to DT Data Loggers and RTUs with Hyperterminal
When you want to change the configuration of DT Data Loggers or RTU, there are commands that could be sent to the DT Data Loggers or RTU via Hyperterminal ...
Fri, 22 Oct, 2021 at 2:16 PM
How to change the Interval of reading data from DT Logger via LoggerNet
When the DT Logger is synched with a FlexDAQ, the interval options settings will be disabled in the DT Logger and the interval is set in the LoggerNet when ...
Thu, 28 Oct, 2021 at 10:17 AM
How to send a new program to a Campbell Scientific CRxxx Logger
To send a new program to a  Campbell Scientific CR xxx Logger, please follow the steps below. 1. Go to Connect Menu: 2. Choose the FlexDAQ station with...
Wed, 1 Dec, 2021 at 8:37 AM
How to enable automatic data collection via LoggerNet at a remote server using an IP address
Situation:  When there is a remote server connected to a hub via LoggerNet, using an IP address. Normally, there will be few steps to setup the server to ...
Thu, 16 Dec, 2021 at 8:59 AM
How to change / Add a new Reading Interval in an RSTAR Program
How to change / Add a new Reading Interval in an RSTAR Program, if there was no reading interval, e.g. for 3 hours (180 minutes), in the existing program. ...
Mon, 10 Jan, 2022 at 3:20 PM
Issue with connecting LoggerNet with CR Logger using Device Congiguration Utility
Many cases, you want to Connect a CR Logger to LoggerNet using Device Configuration Utility by   Go to LoggerNet > Utilities > Device Configuration ...
Mon, 31 Jan, 2022 at 1:33 PM
Error with compling program using CR Basic Editor
Some times, you receive a CR Basic program compiled with a higher version of CR Basic Editor and try to compile before send it to the CR Logger but it ...
Mon, 31 Jan, 2022 at 1:37 PM