DATA LOGGERS

RST Instruments’ Data Loggers nodes and hubs collect and store data from a wide variety of geotechnical sensors and gauges, including vibrating wire and digital microelectromechanical systems (MEMS). They can automatically collect data from the sensor outputs and can be programmed to trigger an alarm when a reading reaches a pre-set critical threshold.

How to set up DT2055B DATA LOGGER WITH VW PIEZOMETER
In order to configure Multichannel DT2055B logger with VW piezometers, please follow the steps below.   1- Connect the VW piezometer wires to the data lo...
Mon, 8 Nov, 2021 at 12:14 PM
How to set up DT2055B data Logger with a 3 Point VW MPBX
To set up a DT2055B data Logger with a 3 Point VW MPBX, please follow the steps below. 1. Connect to the DT2055B Data Logger with DT Logger Host Software....
Tue, 9 Nov, 2021 at 8:25 AM
How to connect a DT2040 Data Logger to VW Multi-Point Borehole Extensometers (MPBX)
This document is intended to be a supplement to the DT Logger Host software manual as it assumes users have a basic understanding of setting up DT series da...
Tue, 6 Feb, 2024 at 9:10 AM
How to setup a DTSAA to read SAA Sensor
1. Connect the USB cable between the PC and the DTSAA logger.  Launch DT Logger Host Software (version 1.19.1+) and wait until the connection is establish...
Wed, 1 Dec, 2021 at 9:47 AM
How to Set up a DT2011B Data Logger with a VW Strain Gauge Sensor
When connecting the VW piezometer wires to the data logger, the wires should be connected to the proper terminal positions on the terminal block.          ...
Mon, 27 Jun, 2022 at 1:15 PM
Setting up a DT2055B Data Logger with a VW Load Cell
On a VW Load cell, there are between 3, 4 or 6 gauges and a thermistor connection. Each has to be set up as a separate channel in the data logger. In the ca...
Tue, 28 Jun, 2022 at 11:16 AM
Setting up a DT2011B Data Logger with a VW Crack Meter or Joint Meter
When connecting the VW Crack Meters or Joint Meters wires to the data logger, the wires should be connected to the proper terminal positions on the terminal...
Tue, 28 Jun, 2022 at 11:18 AM
DT 2485 Logger set-up for RST IPI, Tilt, Liquid Settlement Array Sensor
DT 2485 Series Data Loggers are supporting RST Bus Sensors like IPI (version 3 and 4), Tilt Meters and Precision Liquid Settlement Array Sensors. When setup...
Mon, 11 Jul, 2022 at 9:32 AM
How to setup a VW Piezometer with DT2011B Data Logger
When connecting the VW piezometer wires to the data logger, the wires should be connected to the proper terminal positions on the terminal block.          ...
Fri, 13 Sep, 2024 at 8:56 AM
How to connect Thermistor String with DT2055B Data Logger
Scenario: Customer needs to wire a RST Thermistor String to RST DT2055B Data Logger. Solution: Follow the steps in the guide below to do the job.  This...
Fri, 2 Feb, 2024 at 9:00 AM